Thursday, July 28, 2016

Kitbashing Grand Trunk 719 - Part 7

While the progress on boiler modification is moving at a fast pace, I sprayed the model with black primer to see if there was any obvious defects on the shell. So far, it is better than I thought and touch up will be minimal.

My next challenge was installing inspection and clean out plugs. I had two choices: buy expensive brass parts that don't look like the prototype and are oversized or make them myself. I went with the Red Green's second option as you can guess.

I made the plugs with a combination of holes and 0.040" styrene rod. I first drilled a small pilot hole in the shell of same diameter as the rod.



Then, using a 5/64" drill bit, I enlarged the hole surperficially to create a small recess in the boiler jacket.



Finally, a piece of styrene rod was glued into the small hole. The rod was extending from the surface and was later cut flush with the boiler using a X-Acto blade.



Sure, it lacks the typical rim around the plug, but on many older pictures, it is almost undiscernable. If one would want to make more detailed plugs, I would advise to make the parts independantly, then drill the boiler and insert the plugs. The plugs could be made out of a sprue or a styrene rod with a diameter slightly larger than the largest drilling bit used to shape the plug. Follow my original instruction and you will soon have cheap and easy to install inspection plugs.



To be noted, I also drilled the stanchions mounting holes according to the prototype and enlarged the cab windows. There are still a few holes to drill and running boards to mount.

6 comments:

  1. I am beginning to wonder how much (how little?) of the original will be left y the time you have finished this!

    Simon

    ReplyDelete
    Replies
    1. Ahahah! My exact thoughts! This is heavy kitbashing! On a good side note, the decals are no longer a problem.

      Delete
  2. The original model has provided a supporting framework for what you are building. If you had started from scratch, or even simply started with just the frames, wheels and motion, you would not have progressed so far, so quickly.

    ReplyDelete
    Replies
    1. Exactly. It's a matter of using a well-engineered model as a starting base. Just the fact I don't have to work on motorization is big plus.

      Delete
  3. Matthieu, I've scanned some photos of CV locomotives from this era - for the lettering and a couple of views of similar locomotives to GT 719 that may help with your project. Please send me an email and I'll send you an invite to the Google drive where I have the photos uploaded. - Marty (mjmcguirkATcomcastDOTnet)

    ReplyDelete